Table 16: Auto Provision Settings; Figure 17: Auto Provision Settings - Grandstream Networks UCM6510 User Manual

Enable Zero Config
Automatically Assign Extension
Zero Config Extension
Segment
Enable Pick Extension
Pick Extension Segment
Pick Extension Period (hour):
Firmware Version 1.0.0.5

Figure 17: Auto Provision Settings

Table 16: Auto Provision Settings

Enable or disable the zero config feature on the PBX. The default setting
is disabled.
If enabled, when the device is discovered, the PBX will automatically
assign an extension within the range defined in "Zero Config Extension
Segment" to the device. The default setting is disabled.
Click on the link "Zero Config Extension Segment" to specify the
extension range to be assigned if "Automatically Assign Extension" is
enabled. The default range is 5000-6299.
If enabled, the extension list will be sent out to the device after receiving
the device's request. This feature is for the GXP phones that support
selecting extension to be provisioned via phone's LCD. The default
setting is disabled.
Click on the link "Pick Extension Segment" to specify the extension list to
be sent to the device. The default range is 4000 to 4999.
Specify the number of minutes to allow the phones being provisioned to
pick extensions.
UCM6510 IP PBX User Manual Page 47 of 192