Internal Options/Rtp Settings; Internal Options/Stun Monitor; Table 46: Internal Options/Rtp Settings; Table 47: Internal Options/Stun Monitor - Grandstream Networks UCM6510 User Manual

Jitter Buffer Size
Max Jitter Buffer
Implementation

INTERNAL OPTIONS/RTP SETTINGS

RTP Start
RTP End
Strict RTP
RTP Checksums

INTERNAL OPTIONS/STUN MONITOR

STUN Server
STUN Refresh
Firmware Version 1.0.0.5
Configure the time (in ms) to buffer. This is the jitter buffer size used in
"Fixed" jitter buffer, or used as the initial time for "adaptive" jitter buffer.
The default setting is 100.
Configure the maximum time (in ms) to buffer for "Adaptive" jitter buffer
implementation, or used as the jitter buffer size for "Fixed" jitter buffer
implementation. The default setting is 200.
Configure the jitter buffer implementation on the sending side of a SIP
channel. The default setting is "Fixed".

Fixed
The size is always equal to the value of "Max Jitter Buffer".

Adaptive
The size is adjusted automatically and the maximum value equals to
the value of "Max Jitter Buffer".

Table 46: Internal Options/RTP Settings

Configure the RTP port starting number. The default setting is 10000.
Configure the RTP port ending address. The default setting is 20000.
Configure to enable or disable strict RTP protection. If enabled, RTP
packets that do not come from the source of the RTP stream will be
dropped. The default setting is "Disable".
Configure to enable or disable RTP Checksums on RTP traffic. The
default setting is "Disable".

Table 47: Internal Options/STUN Monitor

Configures the IP address or URL of the STUN server to query. If not
specified, STUN is disabled. The default setting is stun.ipvideotalk.com.
Valid format:
[(hostname | IP-address) [':' port]
The default port number is 3478 if not specified.
Configure the number of seconds between STUN Refreshes. The
default setting is 30 seconds.
UCM6510 IP PBX User Manual Page 147 of 192