Batch Add Extensions; Batch Add Sip Extensions; Table 20: Batch Add Sip Extension Parameters - Grandstream Networks UCM6510 User Manual

Send CallerID After
Other Settings
Fax Detection
Skip Trunk Auth

BATCH ADD EXTENSIONS

BATCH ADD SIP EXTENSIONS

Under web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
SIP Extensions".
General
Start Extension
Create Number
Permission
Enable Voicemail
SIP/IAX Password
Firmware Version 1.0.0.5
Configure the number of rings before sending CID. The default setting is
1.
Enable to detect Fax signal from the user/trunk during the call and send
the received Fax to the Email address configured for this extension. If no
Email address can be found for the user, send the received Fax to the
default Email address
GUI->PBX->Internal Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".

Table 20: Batch Add SIP Extension Parameters

Configure the starting extension number of the batch of extensions to be
added.
Specify the number of extensions to be added. The default setting is 5.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls from this rule.
Enable Voicemail for the user. The default setting is "Yes".
Configure the SIP/IAX password for the users. Three options are
available to create password for the batch of extensions.
UCM6510 IP PBX User Manual
in Fax setting page under web
Page 60 of 192