Sample Configuration For Fax-To-Email; Figure 58: Create Fax Extension; Figure 59: Enable Fax Detection In Analog Trunk - Grandstream Networks UCM6510 User Manual

SAMPLE CONFIGURATION FOR FAX-TO-EMAIL

The following instructions describes a sample configuration on how to use Fax-to-Email feature on the
UCM6510.
1. Connect PSTN line to the UCM6510 FXO port.
2. Go to UCM6510 web GUI->Internal Options->Fax/T.38 page. Create a new Fax extension.
3. Go to UCM6510 web GUI->Basic/Call Routes->Analog Trunks page. Create a new analog trunk.
Please make sure "Fax Detection" is set to "Yes".
4. Go to UCM6510 web GUI->Basic/Call Routes->Inbound Routes page. Create a new inbound route
and set the default destination to the Fax extension.
Firmware Version 1.0.0.5

Figure 58: Create Fax Extension

Figure 59: Enable Fax Detection In Analog Trunk

UCM6510 IP PBX User Manual Page 130 of 192