Table 17: Auto Provision Settings; Figure 27: Auto Provision Settings - Grandstream Networks UCM6510 IP PBX User Manual

Enable Zero Config
Automatically Assign Extension
Zero Config Extension
Segment
Enable Pick Extension
Pick Extension Segment
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

Figure 27: Auto Provision Settings

Table 17: Auto Provision Settings

Enable or disable the zero config feature on the PBX. The default setting
is enabled.
If enabled, when the device is discovered, the PBX will automatically
assign an extension within the range defined in "Zero Config Extension
Segment" to the device. The default setting is disabled.
Click on the link "Zero Config Extension Segment" to specify the
extension range to be assigned if "Automatically Assign Extension" is
enabled. The default range is 5000-6299. Zero Config Extension
Segment range can be defined in web UI->PBX->Internal Options-
>General page->Extension
Extensions".
If enabled, the extension list will be sent out to the device after receiving
the device's request. This feature is for the GXP series phones that
support selecting extension to be provisioned via phone's LCD. The
default setting is disabled.
Click on the link "Pick Extension Segment" to specify the extension list to
be sent to the device. The default range is 4000 to 4999. Pick Extension
Segment range can be defined in web UI->PBX->Internal Options-
UCM6510 IP PBX User Manual
Preference section: "Auto Provision
Page 59 of 229