Grandstream Networks UCM6510 User Manual page 134

Response Timeout
Digit Timeout
Allow Hangup
Once successfully created, users can configure the inbound route destination as "DISA" or IVR key event
as "DISA". When dialing into DISA, users will be prompted with password first. After entering the correct
password, a second dial tone will be heard for the users to dial out.
Firmware Version 1.0.0.5
route's privilege level, the call will be allowed to go through.
Configure the maximum amount of time the UCM6510 will wait before
hanging up if the user dials an incomplete or invalid number. The default
setting is 10 seconds.
Configure the maximum amount of time permitted between digits when
the user is typing the extension. The default setting is 5 seconds.
If enabled, during an active call, users can enter the UCM6510 hangup
feature code (by default it's *0) to disconnect the call or hang up directly.
A new dial tone will be heard shortly for the user to make a new call. The
default setting is "No".
UCM6510 IP PBX User Manual Page 133 of 192