Create New Fxs Extension; Table 19: Fxs Extension Configuration Parameters - Grandstream Networks UCM6510 User Manual

Skip Trunk Auth
Codec Preference

CREATE NEW FXS EXTENSION

To manually create new FXS user, go to web GUI->PBX->Basic/Call Routes->Extensions. Click on
"Create New User"->"Create New FXS Extension" and a new dialog window will show for users to fill in the
extension information. The configuration parameters are as follows.
General
Extension
Analog Station
CallerID Number
Permission
Enable Voicemail
Firmware Version 1.0.0.5
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.

A Specific IP Address
Only the device on the specific IP address can register this
extension.
The default setting is "Allow All".
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
Select audio and video codec for the extension. The available codecs
are: PCMU, PCMA, GSM, AAL2-G.726-32, G,726, G.722, G.729,
G.723, ILBC, ADPCM, H.264, H.263 and H.263p.

Table 19: FXS Extension Configuration Parameters

The extension number associated with the user.
Select the FXS port to be assigned for this extension.
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule.
Enable voicemail for the user. The default setting is "Yes".
UCM6510 IP PBX User Manual Page 57 of 192