Alert Log; Alert Contact; Figure 81: System Events->Alert Events Lists: System Crash; Figure 82: System Events->Alert Log - Grandstream Networks UCM6510 User Manual

6. System Crash

Detect Cycle: The UCM will detect the event at each cycle based on the specified time. Users can
enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
Click on the switch
also select the checkbox for each event and then click on button "Alert On", "Alert Off", "Email Notification
On", "Email Notification Off" to control the alert and Email notification configuration.

ALERT LOG

Under web GUI->Status->System Events->Alert Log, system messages are listed when the alert is
triggered for the configured system events. The following picture shows disk usage alert log. We can tell the
detect cycle for the disk usage is 10 minutes and the disk usage is restored to normal after the administrator
cleans up the disk storage below the threshold.

ALERT CONTACT

Users could add administrator's Email address under web GUI->Status->System Events->Alert Contact
to send the alert notification to. Up to 10 Email addresses can be added.
Firmware Version 1.0.0.5
Figure 81: System Events->Alert Events Lists: System Crash
to turn on/off the alert and Email notification for the event. Users could
Figure 82: System Events->Alert Log
UCM6510 IP PBX User Manual Page 168 of 192