Sip Settings/Misc; Sip Settings/Session Timer; Table 52: Sip Settings/Misc; Table 53: Sip Settings/Session Timer - Grandstream Networks UCM6510 User Manual

From Domain
Auto Domain
Allow External Domains

SIP SETTINGS/MISC

Outbound SIP Registrations
Register Timeout
Register Attempts
Video
Max Bit Rate (kb/s)
Support SIP Video
Generate Manager Events
Reject Non-Matching INVITE

SIP SETTINGS/SESSION TIMER

Session Timers
Firmware Version 1.0.0.5
which can direct the call to a specific context if desired. By default, all
domains are accepted and sent to the default context or the context
associated with the user/peer placing the call. Register to non-local
domains will be automatically denied if a domain list is configured. Up to
10 domains can be added.
Configure the domain in the "From:" header of the SIP message. It may
be required by some providers for authentication.
If enabled, the UCM6510 will add local host name and local IP to domain
list. The default setting is "No".
If enabled, requests for external domains that are not served by the
UCM6510 will be allowed. The default setting is "Yes".

Table 52: SIP Settings/Misc

Configure the register retry timeout (in seconds). The default setting is
20.
Configure the number of registration attempts before the UCM6510
gives up. The default setting is 0, which means the UCM6510 will keep
trying until the server side accepts the registration request.
Configure the maximum bit rate (in kb/s) for video calls. The default
setting is 384.
Select to enable video support in SIP calls. The default setting is "Yes".
If enabled, the UCM6510 will generate manager events when SIP UA
performs events (e.g. Hold). The default setting is "No".
If enabled, when rejecting an incoming INVITE or REGISTER request,
the UCM6510 will always reject with "401 Unauthorized" instead of
notifying the requester whether there is a matching user or peer for the
request. This reduces the ability of an attacker to scan for valid SIP
usernames. The default setting is "No".

Table 53: SIP Settings/Session Timer

Select the session timer mode. The default setting is "Accept".
The options are:
UCM6510 IP PBX User Manual Page 152 of 192