HP storageworks HSG80 Reference Manual page 46

CLI Command Descriptions
ADD STRIPESETS
Names a stripeset and adds it to the controller configuration. A stripeset can contain
from 2 to 24 members. Stripesets are also referred to as RAID level 0 storagesets. The
number of members in the stripeset is determined by the number of container-name
parameters specified.
NOTE: The maximum size of a stripeset is 1.024 TB (1024 GB). The size of a stripeset is
approximated by multiplying the size of the smallest member by the number of members in the
stripeset.
Syntax
ADD STRIPESETS stripeset-name container-name1 container-name2
[container-nameN]
Parameters
The following parameters are required for the ADD STRIPESETS command:
• stripeset-name
• container-name
These parameters are described in the following paragraphs:
stripeset-name
Assigns a name to the stripeset. This is the name used with the ADD UNITS
command to identify the stripeset as a host-addressable unit.
The stripeset-name may consist of up to nine characters excluding commas and
back-slashes.
It is common to name a stripeset STRIPEn, where n is a sequentially assigned,
unique identifier. This naming convention presents to the user both the type of
container and its unique identifier.
container-name1 container-name2 [container-nameN]
Identifies the members (disk drives or mirrorsets) making up the stripeset.
Stripesets can contain between 2 and 24 members.
NOTE: A 256-character limit exists for the command line. If configuring a stripeset with many
members, consider renaming the members to shorter names in order to enter the entire
command line.
2–30 HSG80 Array Controller V8.7 Command Line Interface Reference Guide