HP storageworks HSG80 Reference Manual page 96

CLI Command Descriptions
CANCEL
Turns O
container-name
Causes the device fault LEDs on the devices within the container-name to F
If a device name is given, the device fault LED F
given, the fault LED on all of the devices assigned to the storageset F
DISKS
Causes the device fault LEDs of all configured disks to F
ptl (scsi-port-target-lun)
Causes the device fault LED on the device at the given SCSI location to F
UNITS
Causes the device fault LEDs of all devices used by the units to F
NOTE: This parameter is useful for determining which storage devices are not currently
configured into logical units.
unit-number
Causes the device fault LEDs on the devices making up the unit-number to F
Switches
There are no switches associated with this command.
Examples
To cause the device fault LED on device DISK10000 to F
LOCATE DISK10000
To cause the device fault LEDs on all of the devices assigned to disk unit number
D102 to F
LASH
LOCATE D102
To cause the device fault LEDs on all configured disk devices to F
LOCATE DISKS
To turn O
FF
LOCATE CANCEL
2–80
all device fault LEDs turned O
FF
, enter:
the device fault LEDs that are F
HSG80 Array Controller V8.7 Command Line Interface Reference Guide
with the LOCATE command.
N
. If a storageset name is
LASHES
LASH
, enter:
LASH
on all devices, enter:
LASHING
.
LASH
.
LASHES
.
.
LASH
.
LASH
.
LASH
, enter:
LASH