HP storageworks HSG80 Reference Manual page 139

SET DISABLE_MANAGERS
This command provides the capability to revoke management rights from selected
host connections. A Manager is a host connection that is allowed to issue CLI
commands through a LUN. By default all host connections are enabled as
managers. This command has no effect on CLI commands issued through the
Maintenance Port of the HSG80.
NOTE: This command has no effect on I/O operations. It only affects the host's ability to
issue CLI commands to the HSG80.
NOTE: After issuing SET DISABLE_MANAGERS=ALL, the HSG80 only accepts CLI
commands through the Maintenance Port. Commands from all other sources are rejected
with a SCSI status of ASC:91 ASCQ:08
Syntax
SET DISABLE_MANAGERS=ALL
SET DISABLE_MANAGERS=connection-names
Parameters
There are no parameters associated with this command.
Switches
There are no switches associated with this command.
Examples
To revoke the ability of host1 and host2 to issue CLI commands, enter:
SET DISABLE_MANAGERS=host1,host2
To revoke the ability of all hosts, except host1, to issue CLI commands, enter:
IMPORTANT: The following commands must be issued through the Maintenance Port of the
HSG80. Otherwise all subsequent commands are rejected.
SET DISABLE_MANAGERS=ALL
SET ENABLE_MANAGERS=host1
An alternative way to perform the same functionality, without the restriction of using
the Maintenance Port is by entering:
SET DISABLE_MANAGERS=host2,host3,host4,host5...
HSG80 Array Controller V8.7 Command Line Interface Reference Guide
SET DISABLE_MANAGERS
2–123