HP storageworks HSG80 Reference Manual page 129

Specifies the arbitrated loop physical address (AL-PA) for the host ports (used
only in Fibre Channel arbitrated loop (FC-AL) topology). This switch works only
when LOOP_HARD is specified for the PORT_1_TOPOLOGY or
PORT_2_TOPOLOGY switches. The range of addresses allowed is 0-EF
(hexadecimal).
The factory settings for AL-PA are 71 for port 1 and 72 for port 2. If the controller
memory is wiped out, the AL-PA for both ports defaults to 69.
PORT_1_TOPOLOGY=FABRIC
PORT_2_TOPOLOGY=FABRIC
Specifies switch topology for a host port (used only in Fibre Channel switch
(FC-SW) topology).
PORT_1_TOPOLOGY=LOOP_HARD
PORT_1_TOPOLOGY=LOOP_SOFT
PORT_1_TOPOLOGY=OFFLINE
PORT_2_TOPOLOGY=LOOP_HARD
PORT_2_TOPOLOGY=LOOP_SOFT
PORT_2_TOPOLOGY=OFFLINE
Indicates whether the user or controller selects the AL-PA for a host port, or
whether the port is to be set offline (used only in AL-PA (FC-AL-PA) topology).
LOOP_HARD allows you to pick the AL-PA. LOOP_SOFT requests the
controller to pick the ALPA. OFFLINE sets the host port offline. Specify
OFFLINE for a port when it is not used.
IMPORTANT: If a topology is already selected, topology must be set to offline before another
topology is selected.
PROMPT="new prompt"
Specifies the alpha-numeric characters that are displayed when the ACS command
line interface prompts for input. This display (prompt) may be from 1-16
characters in length (only printable ASCII characters and spaces). The new
prompt name must be enclosed within quotes. When changed, the new text
entered for this switch takes effect immediately.
REMOTE_COPY=node-name
NOREMOTE_COPY
IMPORTANT: This command works in a remote copy environment and requires ACS version
8.7P code. Using either remote copy switch causes the controller to restart.
No other switch can be specified in the same command with the remote copy switches.
HSG80 Array Controller V8.7 Command Line Interface Reference Guide
SET controller
2–113