Command Overview; Controller Commands - HP storageworks HSG80 Reference Manual

CLI Command Introduction
• Using the diagnostic utility protocol (DUP) utility from a system terminal, enable
a remote connection to the controller. After the controller is initially configured
and made visible to the host, other configuration tasks can be performed through
this remote connection.
• Using the SWCC by way of a PC setup on the subsystem. The SWCC can be used
to perform most of the CLI commands that the local terminal can perform.

Command Overview

CLI commands are divided into categories based on the options or structures they
control. The following sections list these command categories.

Controller Commands

Controller commands configure the maintenance terminal characteristics, CLI prompt,
and so forth. These commands are also used to shut down and restart the controller.
There are two types of controller commands: general and failover.
The CLI commands that pertain to the controllers in a general way are:
• CLEAR_ERRORS
• CONFIGURATION
• EXIT
• HELP
• POWEROFF
• RESTART
• SELFTEST
• SET
• SHOW
• RUN
• SHUTDOWN
The CLI commands controlling the failover mode of a controller pair are:
• SET FAILOVER
• SET MULTIBUS_FAILOVER
• SET NOFAILOVER
1–2 HSG80 Array Controller V8.7 Command Line Interface Reference Guide