HP storageworks HSG80 Reference Manual page 70

CLI Command Descriptions
CONFIGURATION SAVE
Forces the controller to copy the subsystem configuration information in its NVRAM
memory onto a configuration file on the disk array. This allows you to know exactly
when a copy of the configuration is saved. The command takes effect immediately.
Use the INITIALIZE container-name SAVE_CONFIGURATION command to set up
the location of the configuration file on the specified container and to save the current
subsystem configuration.
The controller periodically updates the configuration file on the disk array. This
command forces an immediate update. In single-controller subsystems, the
configuration is saved on the disk array. If a container had the
SAVE_CONFIGURATION switch specified when it was initialized (through the
INITIALIZE command), the disks that constitute that unit is able to save a copy of the
configuration.
IMPORTANT: Use this command for a single controller configuration only. StorageWorks does
not recommend using this command for controllers in a dual-redundant configuration.
Syntax
CONFIGURATION SAVE
Parameters
There are no parameters associated with this command.
Switches
There are no switches associated with this command.
Example
To save the subsystem configuration into the memory of the controller in a
single-controller subsystem, enter:
CONFIGURATION SAVE
See Also
CONFIGURATION RESET
CONFIGURATION RESTORE
INITIALIZE
2–54 HSG80 Array Controller V8.7 Command Line Interface Reference Guide