HP storageworks HSG80 Reference Manual page 23

• REJECTED_HOST
These parameters are described in the following paragraphs:
connection-name
The name assigned to the host connection. The connection-name may consist of a
maximum of nine printable characters excluding commas and back-slashes.
The controller automatically assigns default connection name when a connection
is physically made between a host adapter and a controller port. The form of a
default connection name is !NEWCONnn.
HOST_ID=host-id
HOST_ID is the parameter name for the host-id variable, which is the worldwide
name (WWN) of the host. WWN is a 16-character hexadecimal number. The
hyphens are not necessary, but are recommended to avoid mistakes in entering the
number. The HOST_ID parameter name must be entered, followed by an equal
sign, followed by the WWN of the host.
For example, to specify a WWN of AAAA-BBBB-CCCC-DDDD, enter:
HOST_ID=AAAA-BBBB-CCCC-DDDD
ADAPTER_ID=adapter-id
ADAPTER_ID is the parameter name for the adapter-id variable, which is the
worldwide name (WWN) of the host Fibre Channel adapter. WWN is a
16-character hexadecimal number. The hyphens are not necessary, but are
recommended to avoid mistakes in entering the number. The ADAPTER_ID
parameter name must be entered, followed by an equal sign, followed by the
WWN of the host bus adapter.
For example, to specify a WWN of WWN of AAAA-BBBB-CCCC-DDDD,
enter:
ADAPTER_ID=AAAA-BBBB-CCCC-DDDD
NOTE: The worldwide name of the host and adapter are sometimes the same. This is a
characteristic of the adapter.
CONTROLLER=controller
CONTROLLER is the parameter name for the controller variable, which specifies
which controller the host is to connect through. The choices are
THIS_CONTROLLER and OTHER_CONTROLLER.
PORT=port
HSG80 Array Controller V8.7 Command Line Interface Reference Guide
ADD CONNECTIONS
2–7