HP storageworks HSG80 Reference Manual page 83

DELETE unit-number
Deletes a unit from the subsystem configuration.
The DELETE command causes the flushing of any user data from the write-back
cache to the disks and deletes the specified unit. The command deletes the association
of the unit with its underlying device, storageset, RAIDset, or partition. The container
and any data in it are left intact.
If any errors occur when trying to flush the user data, the logical unit is not deleted. To
delete a unit that has existing errors, you must clear all the errors using a
CLEAR_ERRORS command.
Syntax
DELETE unit-number
Parameters
unit-number
Identifies the unit number to be deleted. The unit-number is the same name given
to the unit when it was created using the ADD UNITS command.
Switches
There are no switches associated with this command.
Example
This example shows how to delete disk unit number D103:
DELETE D103
See Also
ADD UNITS
CLEAR_ERRORS
CLEAR_ERRORS LOST_DATA
CLEAR_ERRORS UNWRITEABLE_DATA
DELETE container-name
HSG80 Array Controller V8.7 Command Line Interface Reference Guide
DELETE unit-number
2–67