HP storageworks HSG80 Reference Manual page 40

CLI Command Descriptions
ADD REMOTE_COPY_SETS
Creates a remote copy set (RCS) consisting of one unit at the initiator site and one unit
at the target site. The units may be a single disk (JBOD) or a stripeset, mirrorset, or
RAIDset.
NOTE: This command works only in a DRM environment and requires an HSG80 array
controller with ACS version 8.7P code. Like all DRM commands, use of this command is heavily
restricted. Refer to the StorageWorks by Compaq Data Replication Manager HSG80 ACS
Version 8.7P Operations Guide for examples of usage.
This command must only be used on the initiator (local) site.
The following restrictions apply to remote copy sets:
• There is a maximum of 12 remote copy sets per initiator/target pair.
• Neither initiator nor target units can be transportable units, concatset units, or
snapshot units.
Syntax
ADD REMOTE_COPY_SETS remote-copy-set-name initiator-unit-name
remote-node-name\target-unit-name
Parameters
The parameters required for this command are:
• remote-copy-set-name
• initiator-unit-name
• remote-node-name\target-unit-name (this parameter is not required; it can be
added later through the SET command)
These parameters are described in the following paragraphs:
remote-copy-set-name
The name by which the remote copy set is known. This name must be unique
across the fabric.
NOTE: Remote copy sets cannot be renamed with the RENAME command. If the wrong name
is entered, the remote copy set must be deleted and then added again.
The remote-copy-set-name may consist of a maximum of nine characters
excluding commas and back-slashes.
initiator-unit-name
2–24 HSG80 Array Controller V8.7 Command Line Interface Reference Guide