HP storageworks HSG80 Reference Manual page 134

CLI Command Descriptions
SET device-name
Enables changes to the transfer rate and transportable characteristics of the specified
disk drive.
Syntax
SET device-name
Parameter
device-name
Specifies the name of the device to change, such as disk or passthrough device.
Switches
The following switches are available to the SET device-name command:
• TRANSFER_RATE_REQUESTED
• TRANSPORTABLE and NOTRANSPORTABLE
These switches are described in the following paragraphs:
TRANSFER_RATE_REQUESTED=ASYNCHRONOUS
TRANSFER_RATE_REQUESTED=DEFAULT
TRANSFER_RATE_REQUESTED=20MHZ (default)
TRANSFER_RATE_REQUESTED=10MHZ
TRANSFER_RATE_REQUESTED=5MHZ
Specifies the maximum data transfer rate for the controller to use in
communicating with the device. You may need to limit the transfer rate to
accommodate long cables between the controllers and the device.
NOTE: This switch is used by all container types.
TRANSPORTABLE
NOTRANSPORTABLE
Indicates whether a disk can be accessed exclusively by StorageWorks controllers
(the TRANSPORTABLE switch is used for disks only).
NOTE: This switch works only if the disk drive is not used by a higher level assembly, such as a
storageset or a unit, and is used by disk containers only.
• Storagesets cannot be made transportable.
2–118 HSG80 Array Controller V8.7 Command Line Interface Reference Guide