HP storageworks HSG80 Reference Manual page 157

SET remote-copy-set-name
Changes the characteristics of a remote copy set.
NOTE: This command works only in a DRM environment and requires an HSG80 array
controller with ACS version 8.7P code. Like all DRM commands, use of this command is heavily
restricted. Refer to the StorageWorks by Compaq Data Replication Manager HSG80 ACS
Version 8.7P Operations Guide for examples of usage.
This command works only on the site that is functioning as initiator.
Syntax
SET remote-copy-set-name
Parameters
remote-copy-set-name
Specifies the name of the remote copy set to modify. This is the name used with
the ADD REMOTE_COPY_SETS command to identify the remote copy set as a
host-addressable unit.
Switches
The following switches are available to the SET remote-copy-set-name command:
• ADD
• ERROR_MODE
• INITIATOR
• OPERATION_MODE
• OUTSTANDING_IOS
• REMOVE
• RESUME
• SUSPEND
These switches are described in the following paragraphs:
ADD=remote-node-name\target-unit-name
Specifies a unit to add into the remote copy set.
HSG80 Array Controller V8.7 Command Line Interface Reference Guide
SET remote-copy-set-name
2–141