LOCATE
Facilitates discovery of the physical location of configured units, storagesets, and
devices by F
F
LED helps to distinguish between located devices and failed devices.
LASHING
The LOCATE command causes the device fault LED to function as follows:
•
F
once per second on a good device. The LED turns O
LASH
CANCEL command.
•
Illuminate continuously on a failed device. The LED stays O
turned O
NOTE: The LOCATE command can also be used to test the device fault LED.
Not all devices provide a device fault LED; therefore, these devices cannot be identified using
the LOCATE command.
Syntax
LOCATE parameter
Parameters
The following parameters are available to the LOCATE command:
•
ALL
•
CANCEL
•
container-name
•
DISKS
•
ptl
•
UNITS
•
unit-number
These parameters are described in the following paragraphs:
NOTE: Only one of the following parameters can be entered with each LOCATE command.
ALL
Causes the device fault LEDs of all configured devices to F
specify ALL to test all of the LEDs at once.
HSG80 Array Controller V8.7 Command Line Interface Reference Guide
the device fault LED on the front of the storage device. A
LASHING
with the LOCATE CANCEL command.
FF
LOCATE
with the LOCATE
FF
even after being
N
. You can also
LASH
2–79