HP storageworks HSG80 Reference Manual page 106

CLI Command Descriptions
RENAME
Renames a specified container or specified host connection.
NOTE: Units, remote copy sets, and association sets cannot be renamed.
Syntax
RENAME old-container-name new-container-name
Parameters
The following parameters are available to the RENAME command:
• old-container-name
• new-container-name
These parameters are described in the following paragraphs:
old-container-name
Specifies the existing name of the container or host connection.
new-container-name
Assigns the new name for the container or host connection.
A name of a host connection can be any combination of letters and numbers, with
the one restriction that it cannot take the form of the default assigned by the
controller (!NEWCONnn).
Switches
There are no switches associated with this command.
Example
To change the name of DISK10000 to MYDISK, enter:
RENAME DISK10000 MYDISK
To change the name of host connection !NEWCON03 to server2, enter:
RENAME !NEWCON03 SERVER2
2–90 HSG80 Array Controller V8.7 Command Line Interface Reference Guide