Section Emenu Option 4 Preferences - Hologic ThinPrep Operator's Manual

SECTION
E
MENU OPTION 4 PREFERENCES
Preferences allows the setting of user preferences including Autoscan settings and maximum speed
for Autolocate. For each user-selectable preference, the console display shows the current setting of
the parameter. Use the pod buttons to change the setting to the desired value. The setting is stored
locally (in RS memory) until the user preferences are updated on the Server during user Logout.
Note:
Preferences are not saved until Logout. At the next Login, the preferences for that User ID will
be uploaded.
From the main menu, select option 4, Preferences. All three 'pages' of the menu are shown below. To
select an option, press the corresponding number key on the console keypad. Press the More or Back
soft keys to move from page to page of the menu.
1 Scan Dir.
2 Scan Type
3 Scan Overlap
Note:
Refer to the preferences worksheet at the end of this chapter, when evaluating and recording
preference settings.
Preferences 1 Scan Direction
The direction of the stage movement during autoscan can be selected. From the preferences menu,
select 1, Scan Dir. The direction options are Left/Right or Up/Down. Press the cancel key
time to exit out of menus.
On the console keypad press the number key corresponding to your choice. The selected direction
will have a highlighted box around it. Press the Save soft key to save that preference. The scan direc-
tion setting will now be used during this login session and will be saved to the user preferences pro-
file at logout.
O
PERATION OF THE
4 Autolocate
5 Joystick Setup
6 Beep Volume
Back
More
1 Left/Right
2 Up/Down
S M
OFTWARE
More
Save
Review Scope Operator's Manual
4
ENU
7 Button Setup
8 Reset Defaults
Back
⊗
at any
4.13