Hologic ThinPrep Operator's Manual page 106

4
O
PERATION OF THE
An Autolocate Test display appears. Look through the eyepieces and repeatedly press the Next but-
ton on the pod to observe the speed of the stage motion. Press the Finish soft key return to the auto-
locate speed setting display.
To adjust the speed setting, press the Next and Prev buttons on the pod to increase or decrease
the speed setting. Press the Test soft key. Repeat this process until the setting is as desired.
To save this setting, press the Save soft key. The autolocate speed setting will now be used
during this login session and will be saved to the user preferences profile at logout.
Mark Indicator On/Off
The white mark indicator may be turned off during autolocate.
If it is preferred that the mark indicator always be visible during slide review, select Mark Always
ON. Press 1 on the keypad and then press the Save softkey.
If it is preferred that the mark indicator is not visible during slide review, select Mark Turns OFF.
Press 2 on the keypad and the press the Save softkey. The white mark indicator will remain off until
the operator moves the joystick, or presses the Mark button.
Note:
the green mark indicator is unaffected by the preference setting.
Note:
Refer to the preferences worksheet at the end of this chapter, when evaluating and recording
preference settings.
4.20 Review Scope Operator's Manual
S M
OFTWARE ENU
Autolocate Test
Press Next
Finish
Autolocate
1 Mark Always ON
2 Mark Turns OFF
Save