Hologic ThinPrep Operator's Manual page 110

4
O
PERATION OF THE
Preferences 7 Button Setup
The function buttons on the pod may be reassigned to fit user preference. From the preference menu,
select 7, Button Setup. Press the cancel key
for defaults.
Previous
The button setup display shows the current orientation of button functions. To reconfigure the set-
ting, press the Change soft key on the key pad. The pod buttons will be reconfigured in this order:
Next, Previous, Objective, Mark.
The pod button locations are represented by empty brackets. The display prompts to press the button
the you would prefer to act as the Next button on the pod. Press the actual button on the pod that will
be assigned as the Next button. (The configuration in the following displays are for example, only.)
4.24 Review Scope Operator's Manual
S
OFTWARE
⊗
at any time to exit out of menus. Refer to Figure 4-10
Objective
Next
Mark
Joystick
4-Button Pod
Note: Only one pod is used
Figure 4-10 Pod Button Defaults
Button Setup
[Next]
[Prev]
Select Next
[ ]
[ ]
M
ENU
5-Button Pod
[Obj.]
[Mark]
Change
[ ]
[ ]
Next
Previous
Mark
Joystick
Objective
(both sides)