Hologic ThinPrep Operator's Manual page 56

2
I
NSTALLATION
Marking Pen
CAUTION: The marking pen should ONLY be loaded by performing the Calibrate
Marker function via the software menu.
Certain models of the ThinPrep Review Scope (model numbers 70669-001, 70669-002, and 70669-003)
require a different pen and special setup instructions.
®
The marking pen for some models of the ThinPrep Review Scope is a Sharpie Ultra Fine Point
marking pen. Only use this specified marker for ThinPrep Review Scope model numbers 70575-001,
70575-003, 71062-001, and 71062-002. (Refer to Figure 2-6.)
®
Figure 2-6 Sharpie Marking Pen
The marking pen for the other models of the ThinPrep Review Scope is a Pilot Extra Fine Point mark-
ing pen. Only use this specified marker for ThinPrep Review Scope model numbers 70669-001,
70669-002, and 70669-003. (Refer to Figure 2-7.)
Figure 2-7 Pilot Marking Pen
The marking pen must be present for physical marking of the slide at the conclusion of a review.
Loading the marking pen should only be done by executing "Calibrate Marker" from the Review
Scope software menu. (Refer to Marker Calibration on page 4.8.)
Focus Knob Covers
Rubber knob covers for the fine focus knobs are available. They are placed over the focus knob and
remain in place via a friction fit. (Refer to Figure 2-8.) Contact Hologic Technical Support to request
them.
2.6 Review Scope Operator's Manual