The Next button position is shown on the display. Select the location for the Previous button. Press
the actual button on the pod that will be assigned as the Previous button.
The Next and Previous button position are shown on the display. Select the location for the Mark
button. Press the actual button on the pod that will be assigned as the Mark button.
As soon as the Mark button is located, the Objective button position is automatically filled in the
remaining empty location.
Press the Save soft key on the key pad to save the new configuration.
Note:
Refer to the preferences worksheet at the end of this chapter, when evaluating and recording
preference settings.
O
PERATION OF THE
Select Prev
[
]
[Next]
[
]
[
]
Button Setup
[
Obj.
]
[Next]
[Mark] [Prev ]
Save
Button Setup
[ Obj. ]
[Next]
[Mark] [Prev ]
Save
S
M
OFTWARE
ENU
Review Scope Operator's Manual
4
4.25