Hologic ThinPrep Operator's Manual page 112

4
O
PERATION OF THE
Preferences 8 Reset Defaults
Preferences associated with the active user ID may be restored to the factory default settings, if
desired. All settings will return to the default configuration.
From the preferences menu, select 8, Reset Defaults.
The default values for the parameters that may change are restored. The default values are:
Left/Right scan direction
Auto Start-Stop, scan speed at 50
Pause duration at 50
Autoscan Overlap at minimum
Autolocate speed at 90
Mark Indicator always ON
User based frame of reference, speed at 50
Beep volume at 50
Pod button arrangement
Previous
4.26 Review Scope Operator's Manual
S
OFTWARE
Objective
Next
Mark
Joystick
4-Button Pod
Note: Only one pod is used
Figure 4-11 Pod Button Defaults
M
ENU
5-Button Pod
Next
Previous
Mark
Joystick
Objective
(both sides)