Hologic ThinPrep Operator's Manual page 102

4
O
PERATION OF THE
Auto Start-Stop Scan
To select Auto Start-Stop Scan, press 2 on the console keypad and then press the Save soft key. For
this preference, a scan speed setting (the speed of the stage moving from field of view to field of
view) and the pause duration will be adjusted and saved. Press the cancel key
out of menus.
Prev Button
A speed setting display shows a highlighted bar with the current speed setting (default is 50). Press
the Next button on the pod to increase the speed value. Press the Prev button on the pod to decrease
the speed value.
When the speed has been changed, select the Test soft key on the console to view the speed of the
stage motion between fields of view.
The Auto Start-Stop Preference Test display appears. The stage begins to move at the speed of the
new setting. Look through the eyepieces to observe the speed.
Press the Next button on the pod to return to the Speed Setting display. If the speed setting needs
adjustment, repeat adjusting the speed and testing it until achieving the desired results.
When the scan speed is acceptable, press the Save soft key. The display then changes to the Pause
Duration setup screen.
4.16 Review Scope Operator's Manual
S
OFTWARE
1 Continuous
2 Auto ST/SP
3 Manual ST/SP
Speed Setting
S
<=
<=
Test
Auto ST/SP
Preference Test
Press Next
M
ENU
Save
Next Button
F
50 =>
Save
⊗
at any time to exit
=>