Omron F3SG series User Manual page 68

System Operation and Functions
Information Name
Lockout information
Excess power-on time
information
Excess load switching
frequency information
Light level diagnosis
information
Blanking/Warning-zone
information
Muting information
Override information
Muting/Override information
Sequence error information
Warning Zone Information
Blanking bream unblocked
information
Designated beam output
information
Interference/vibration
information
Troubleshooting support
signal
Individual cascaded sensor
output (Channel 1)
Individual Cascaded Sensor
Output (Channel 2)
Individual Cascaded Sensor
Output (Channel 3)
Make sure the Position 8 of the DIP Switch is set to Configuration Tool Enabled to activate the settings by the
Configuration Tool.
Refer to Safety Light Curtain Configuration Tool for Model F3SG (SD Manager 2) User's Manual for more
information on setting this function by the Configuration Tool.
F3SG-R
44
User's Manual
(Auxiliary output is turned ON under the following condition)
Under error/ Lockout state
When power-on time exceeds power-on time threshold
When load switching frequency exceeds load switching frequency threshold
When the F3SG-R is unblocked and light intensity is within a range from 100% to 170% of ON-
threshold for 10 s or longer
When Fixed Blanking, Floating Blanking, Reduced Resolution or Warning Zone function is
enabled
Under Muting state
Under Override state
Under either Muting or Override state
Under Muting sequence error state or Interlock sequence error state
When warning zone is interrupted
When Fixed-Blanking or Floating Blanking beams are unblocked
When a designated beam is blocked or unblocked
When the F3SG-R system stops accidentally due to interference or vibration. (In case of
cascade connection, when any of cascaded segments comes under this condition.)
When one of the signals of Sequence error information, Interference/vibration information and
Light level diagnosis information is in the ON state.
When Safety output of Primary sensor in cascade connection is the ON state
When Safety output of 1st Secondary sensor in cascade connection is the ON state
When Safety output of the 2nd Secondary sensor in cascade connection is the ON state
Description