Siemens SINUMERIK 840D sl Operating Manual page 96

Setting up the machine
2.6 Measuring the workpiece zero
2 holes
3 holes
96
- OR -
• If you do not make any entry in the entry field "Øhole", then the axis
moves with the measuring feed from the starting point. If the
measuring stroke does not reach the edge of the hole, then the
approximate diameter must be entered. However, the measuring
sequence is then also shortened as part of the measuring distance is
moved with rapid traverse.
• In "Angle offs.", select entry "Coord. rotation".
- OR -
In "Angle offs.", select the "Rotary axis A, B, C" entry.
• Enter the setpoint angle.
• Specify the position setpoints (X1/Y1) for the center point of the first
hole.
X1 and Y1 are only active, if the "Coor. rotation" entry is selected.
- OR -
• If you do not make any entry in the entry field "Øhole", then the axis
moves with the measuring feed from the starting point. If the
measuring stroke does not reach the edge of the hole, then the
approximate diameter must be entered. However, the measuring
sequence is then also shortened as part of the measuring distance is
moved with rapid traverse.
• In "Angle offs." select entry "No".
- OR -
In "Angle offs." select entry "Yes" if you want alignment to be
performed with coordinate rotation.
• Enter the setpoint angle.
The angle entered here refers to the 1st axis of the working plane
(X/Y plane). This input field only appears if you specified "Yes" for
"Angle offs."
• Specify setpoint positions X0 and Y0.
These determine the center point of the circle on which the center
points of the three holes are to lie.
- OR -
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
Milling