Status Display - Siemens SINUMERIK 840D sl Operating Manual

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

7
Display for
active tool T
current feedrate F
active spindle with current status (S)
Spindle utilization rate in percent
8
Operating window with program block display
9
Display of active G functions, all G functions, auxiliary functions and input window for different functions (for
example, skip blocks, program control).
10
Dialog line to provide additional user notes.
11
Horizontal softkey bar
12
Vertical softkey bar
Figure 1-3
User interface
1.4.2

Status display

The status display includes the most important information about the current machine status
and the status of the NCK. It also shows alarms as well as NC and PLC messages.
Depending on your operating area, the status display is made up of several lines:
● Large status display
● Small status display
Status display of "Machine" operating area
First line
Display
Active operating area
Milling
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
The status display is made up of three lines in the "Machine" operating area.
In the "Parameter", "Program", "Program Manager", "Diagnosis" and "Start-up" operating
areas, the status display consists of the first line from the large display.
Description
"Machine" operating area
With touch operation, you can change the operating area here.
"Parameter" operating area
"Program" operating area
Introduction
1.4 User interface
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828d

Table of Contents