Siemens SINUMERIK 840D sl Operating Manual page 611

Service Planner
Display
Pos
Maintenance task
Interval [h]
1. warning [h]
Number of warnings
Remaining time [h]
Status
Procedure
Milling
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
Meaning
Position of the maintenance task in the PLC interface.
Name of the maintenance task.
Maximum time until next servicing in hours.
Time in hours at which an initial warning is displayed.
Number of warnings that can be acknowledged by the operator before
an alarm message is output for the last time.
Time until the interval expires in hours.
The remaining time cannot be edited.
Display of the current status of a maintenance task.
The maintenance task has been started.
The maintenance task is completed.
The maintenance task is deactivated, i.e. the time has been
stopped.
The status cannot be edited.
1. Select the "Diagnostics" operating area.
2. Press the menu forward key and then the "Service planner" softkey.
The window opens and displays a list of all the tasks that have been set
up.
The values cannot be edited.
3. Press the "New maintenance task" softkey to set up a new maintenance
task.
A message informs you that a new maintenance task will be set up at
the next free position. Enter the required data in the columns and press
the "OK" softkey.
- OR -
Position the cursor on the desired maintenance task and press the
"Change task" softkey to change the associated times.
All columns except Remaining time and Status can be edited.
Service Planner (828D only)
19.2 Set maintenance tasks
611