Programming technological functions (cycles)
8.1 Drilling
XYA plane
You program in XYA if the Y axis should also move during machining. A value can be
specified for each position. In addition to the possibilities of XA, the following is also possible,
for example.
Procedure
Parameter
Description
LAB - (only for G
Repeat jump label for position
code)
PL
- (only for G
Machining plane
code)
298
1.
The part program or ShopMill program to be processed has been
created and you are in the editor.
2.
Press the "Drilling" softkey.
3.
Press the "Positions" softkey.
The "Positions" input window opens.
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
Unit
Milling