Set Maintenance Tasks - Siemens SINUMERIK 840D sl Operating Manual

Service Planner (828D only)

19.2 Set maintenance tasks

Procedure
Note
You can perform the maintenance tasks before the interval expires. The maintenance
interval is restarted.
19.2 Set maintenance tasks
You can make the following changes in the list of maintenance tasks in the configuration
mode:
● Set up a maximum of 32 maintenance tasks with interval, initial warning and number of
● Change the interval, time of the initial warning and the number of warnings to be output
● Delete a maintenance task
● Reset the times of the maintenance tasks
Acknowledging a maintenance task
You can acknowledge the maintenance tasks with the "Servicing performed" softkey.
Note
Protection level
You require protection level 1 (manufacturer) to set up and edit maintenance tasks.
610
1. Select the "Diagnostics" operating area.
2. Press the menu forward key and then the "Service planner" softkey.
The window with the list of all the maintenance tasks that have been set
up appears.
3. Perform the maintenance task when the maintenance interval has
nearly expired or when prompted to do so by alarms or a warning.
4. After you have performed a pending maintenance task and the task is
signaled as "Completed", position the cursor at the appropriate task and
press the "Servicing performed" softkey.
A message is displayed confirming the acknowledgment, and the
maintenance interval is restarted.
warnings to be acknowledged
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
Milling