Siemens SINUMERIK 840D sl Operating Manual page 347

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

Note
Entering the engraving text
Only single-line entries without line break are permissible!
Milling
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
< #,_VAR_NUM>
<#.,_VAR_NUM>
<#.#,_VAR_NUM>
<#.##,_VAR_NUM>
<#.####,_VAR_NUM> 12.3500
If there is insufficient space in front of the decimal point to display the
number entered, it is automatically extended. If the specified number of
digits is larger than the number to be engraved, the output format is
automatically filled with the appropriate number of leading and trailing
zeroes.
Instead of the decimal point you can also use a blank.
Instead of _VAR_NUM you can use any other numerical variable (e.g.
R0).
7.
Press the "Variable" and "Variable text" softkeys if you want to take the
text to be engraved (up to 200 characters) from a variable.
The format text <Text, _VAR_TEXT> is inserted and you return to the
engraving field with the softkey bar.
You can use any other text variable instead of _VAR_TEXT.
Programming technological functions (cycles)
12
4 places before decimal point,
leading blanks, no places after the
decimal point
12.35
Integer and fractional digits not
formatted.
12.4
Places before decimal point
unformatted,
1 place after the decimal point
(rounded)
12.35
Places before decimal point
unformatted,
2 places after the decimal point
(rounded)
Places before decimal point
unformatted,
4 places after the decimal point
(rounded)
8.2 Milling
347

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828d

Table of Contents