Grooving Residual Material (Cycle952) - Siemens SINUMERIK 840D sl Operating Manual

Programming technological functions (cycles)
8.5 Contour turning - only for G code programs
8.5.10

Grooving residual material (CYCLE952)

Function
The "Grooving residual material" function is used when you want to machine the material
that remained after grooving along the contour.
For a G code program, first select the "Grooving residual material" function. Material that
remains as part of the finishing allowance is not residual material. The "Grooving residual
material" function allows you to remove unwanted material with a suitable tool.
The "Grooving residual material" function is a software option.
Procedure
Parameters, G code program
PRG Name of the program to be generated
PL Machining plane
RP Retraction plane – (only for
longitudinal machining
direction)
SC Safety clearance
F Feedrate
CON Name of the updated blank contour for
residual material machining (without the
attached character "_C" and double-digit
number)
Residual With subsequent residual material removal
material
Yes
•
No
•
CONR Name to save the updated unmachined-part
contour for residual material removal – (only
"Yes" for residual material removal)
430
1. The part program to be executed has been created and you are in the
editor.
2. Press the "Turning" and "Contour turning" softkeys.
3. Press the "Grooving residual material" softkey.
The "Grooving residual material" input window is opened.
mm
mm
*
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
Milling