Siemens SINUMERIK 840D sl Operating Manual page 186

Machining the workpiece
4.14 Setting for automatic mode
References
Programming Manual Measuring Cycles / 840D sl/828D
Note
The feedrate can be changed while the operation is running.
See also
Program control (Page 158)
186
5. Enter the desired percentage in the "Reduced rapid traverse RG0" field.
RG0 has not effect if you do not change the specified amount of 100%.
6. Enter "Automatic" in the "Display measurement result" box if the
measurement result window should be automatically opened, or
"Manual", if the measurement result window should be opened by
pressing the "Measurement result" softkey.
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
Milling