4.4.5
Manual grooving/parting
Functionality
The manual grooving function is suitable for producing grooves on the peripheral surface and face end and for tapping
turned parts. Groove cycles can be used to produce filleted corners or beveled edges on surfaces.
In addition, the multiple execution function can be used to produce multiple tappings and multiple grooves with a uniform
offset.
Note
The grooving tool must be configured in the tool list; in doing so, the width of the tool must be programmed via the panel
width or via cutting edge 1 (D1) or cutting edge 2 (D2).
4.4.5.1
Groove cycle - single
Operating sequences
Programming and Operating Manual (Manual Machine Plus (MM+), Turning)
01/2017
1.
You can access the grooving cycle overview by pressing this softkey in the basic screen for
MM+.
2.
You can access the manual grooving function by pressing this softkey in the grooving cycle
overview.
Alternatively, you can select this function with cursor keys and activate it with this hardkey.
37