Stabilize The Rack; Installing The Standard 19-Inch Hardmount Kit (4-Post Rack) - Oracle Netra SPARC S7-2 Installation Manual

Related Information
"Handling Precautions" on page 28
■
"ESD Precautions" on page 29
■
"Stabilize the Rack" on page 33
■

Stabilize the Rack

Caution -
devices before installing the server.
Refer to your rack documentation for detailed instructions for the following steps.
Note -
1. Open and remove the front and rear doors from the rack cabinet.
To prevent the rack cabinet from tipping during the installation, stabilize the
2.
cabinet using all antitilt mechanisms provided.
3. If there are leveling feet beneath the rack cabinet to prevent it from rolling,
extend these leveling feet fully downward to the floor.
4. Fully extend the rack cabinet's antitilt legs or antitilt bar, which are located at the
bottom front of the rack cabinet.
Related Information
Documentation for your rack cabinet
■
Netra SPARC S7-2 Server Safety and Compliance Guide, Compliance Model No.: 9600
■
"Shipping Kit Inventory" on page 27
■
"Handling Precautions" on page 28
■

Installing the Standard 19-Inch Hardmount Kit (4-Post Rack)

These topics provide installation instructions for the 19-inch, 4-post hardmount kit that ships
with the server.
To reduce the risk of personal injury, stabilize the rack cabinet and extend all antitilt
In this document, the term rack means either an open rack or a closed cabinet.
Stabilize the Rack
Installing the Server 33