Netra Sparc S7-2 Server Installation Guide • January - Oracle Netra SPARC S7-2 Installation Manual

Assign a Static IP Address to the NET MGT Port
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 87
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 88
■
Assign a Static IP Address to the NET MGT Port
If you plan to connect to the SP through its NET MGT port, the SP must have a valid IP
address.
By default, the server is configured to obtain an IP address from DHCP services in your
network. If the network your server is connected to does not support DHCP for IP addressing,
perform this procedure.
Note -
Connect to the Oracle ILOM on the SP using the SER MGT port.
1.
If you are not already connected through the SER MGT port, perform steps as needed in
"Connect a Terminal or Emulator to the SER MGT Port" on page
Set the SP to accept a static IP address.
2.
->set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
3. Set the IP address for the SP.
To change the default IPv4 DHCP property and set property values for a
■
static IPv4 address, type
To change the default IPv6 DHCP property and set property values for a
■
static IPv6 address, type
->set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
4. Set the IP address for the SP gateway.
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
5. Set the netmask for the SP.
-> set /SP/network pendingipnetmask=255.255.255.0
92 Netra SPARC S7-2 Server Installation Guide • January 2017
To configure the server to support DHCP, refer to the Oracle ILOM documentation.
.
IPv4_address
.
IPv6_address
81.