Oracle Netra SPARC S7-2 Installation Manual page 93

Set 'pendingipnetmask' to '255.255.255.0'
This example uses 255.255.255.0 to set the netmask. Your network environment subnet might
require a different netmask. Use a netmask number most appropriate to your environment.
6. Verify that the parameters were set correctly.
This example shows parameters that have been set to convert a SP from a DHCP configuration
to a static configuration.
-> show /SP/network -display properties
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_clientid = xxx.xxx.xxx.xxx
dhcp_server_ip = xxx.xxx.xxx.xxx
ipaddress = xxx.xxx.xxx.xxx
ipdiscovery = dhcp
ipgateway = xxx.xxx.xxx.xxx
ipnetmask = 255.255.255.0
macaddress = xx:xx:xx:xx:xx:xx
managementport = MGMT
outofbandmacaddress = xx:xx:xx:xx:xx:xx
pendingipaddress = service-processor-IPaddr
pendingipdiscovery = static
pendingipgateway = gateway-IPaddr
pendingipnetmask = 255.255.255.0
pendingmanagementport = MGMT
sidebandmacaddress = xx:xx:xx:xx:xx:xx
state = enabled
->
7. Set the changes to the SP network parameters.
-> set /SP/network commitpending=true
Set 'commitpending' to 'true'
You can type the show /SP/network command again to verify that the parameters have
Note -
been updated.
8. Set the static IP address when you configure the Oracle Solaris OS.
See "Configure the Preinstalled OS" on page
Related Information
Server Administration
■
Assign a Static IP Address to the NET MGT Port
86.
Powering On the Server for the First Time 93