Stabilize The Rack - Oracle SPARC T8-1 Installation Manual

Stabilize the Rack

Caution -
and mount this 2U server into a rack enclosure when using the procedures in this document.
Related Information
"Physical Specifications" on page 19
■
"Handling Precautions" on page 17
■
"Stabilize the Rack" on page 28
■
Stabilize the Rack
Caution -
devices before installing the server.
Refer to the rack documentation for detailed instructions for the following steps.
1. Read the rack cautions and stabilize the rack.
See "Rack Cautions" on page
Open and remove the front and rear doors from the rack.
2.
3. To prevent the rack cabinet from tipping during the installation, stabilize the
cabinet using all antitilt mechanisms provided.
If there are leveling feet beneath the rack to prevent it from rolling, extend these
4.
leveling feet fully downward to the floor.
5. Install the rackmount hardware.
See "Install the Rackmount Hardware" on page
28 SPARC T8-1 Server Installation Guide • June 2019
The server weighs approximately 60 lb (27.22 kg). Two people are required to lift
To reduce the risk of personal injury, stabilize the rack by extending all antitilt
27.
29.