Install The Storage Server Into The Rack; Stabilize The Rack For Installation - Oracle Exadata Storage Server X6-2 High Capacity Installation Manual

Install the Storage Server Into the Rack

Use the following procedures to add the storage server to the rack:
"Stabilize the Rack for Installation" on page 29
■
"Install Mounting Brackets" on page 30
■
"Mark the Rackmount Location" on page 31
■
"Connect AC Power Cables Before Installing Tool-less Slide-Rails in Sun Rack II
■
1042" on page 33
"Attach Tool-Less Slide-Rail Assemblies" on page 35
■
"Install the Storage Server Into the Slide-Rail Assemblies" on page 38
■
"Verify Operation of Slide-Rails and Cable Management Arm" on page 52
■
"Install the Cable Management Arm" on page 40
■

Stabilize the Rack for Installation

Caution -
devices before installing the storage server.
Refer to your rack documentation for detailed instructions for the following steps.
1. Open and remove the front and rear doors from the rack cabinet.
Note -
To prevent the rack cabinet from tipping during the installation, fully extend the
2.
rack cabinet's anti-tilt legs or anti-tilt bar, which are located at the bottom front of
the rack cabinet.
If there are leveling feet beneath the rack cabinet to prevent it from rolling,
3.
extend these leveling feet fully downward to the floor.
Caution -
feet are up before moving the rack.
After the cabinet is installed in its location, you can use the shipping brackets to
4.
secure the cabinet to the floor.
To reduce the risk of personal injury, stabilize the rack cabinet, and extend all anti-tilt
The front and rear doors need to be removed only if they impinge on the mounting bay.
When moving the rack to a new location, including repacking, verify that the leveling
Install the Storage Server Into the Rack
Installing the Storage Server Into a Rack 29