Rip Database - D-Link DXS-3400 SERIES Web Ui Reference Manual

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Network
Passive Interface
BFD State
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.

RIP Database

This window is used to display the Routing Information Protocol (RIP) routing database. Summary address entries will
appear in the database only if relevant child routes exist and are being summarized. When the last child route for a
summary address becomes invalid, the summary address is also removed from the routing table.
To view the following window, click L3 Features > RIP > RIP Database, as shown below:
The fields that can be configured are described below:
Figure 6-30 RIP Interface Settings Window
Description
Enter the IPv4 network address used by RIP here. The interface that has a subnet
defined belonging to a network specified here will be activated with RIP.
Select to enable or disable the passive interface feature here. This feature is used
to disable the sending of routing updates on an interface. However, RIP packet
from other routers received on this interface will continue to be processed.
Enter the name of the passive interface in the space provided. This name can be
up to 12 characters long.
Select the Default option to use the global default passive state for all interfaces.
Select to enable or disable the BFD feature on the specified interface. When BFD
is enabled on an interface, the router creates BFD peers with the current RIP
peers of the interface, and BFD peers will be created when new RIP peers are
added. If an RIP peer is removed because RIP is disabled, the related BFD peer
will be removed. When the BFD session goes down, the RIP routes learned from
the peer will be deleted.
Figure 6-31 RIP Database Window
211