D-Link DXS-3400 SERIES Web Ui Reference Manual page 335

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
The fields that can be configured in ARP Inspection Validation are described below:
Parameter
Src-MAC
Dst-MAC
IP
Click the Apply button to accept the changes made.
The fields that can be configured in ARP Inspection Filter are described below:
Parameter
ARP Access List Name
VID List
Static ACL
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove an entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Figure 9-46 ARP Inspection Settings Window
Description
Select to enable or disable the source MAC option here. This option specifies to
check for ARP requests and response packets and the consistency of the source
MAC address in the Ethernet header against the sender MAC address in the ARP
payload.
Select to enable or disable the destination MAC option here. This option specifies
to check for ARP response packets and the consistency of the destination MAC
address in the Ethernet header against the target MAC address in the ARP
payload.
Select to enable or disable the IP option here. This option specifies to check the
ARP body for invalid and unexpected IP addresses. It also specifies to check the
validity of IP address in the ARP payload. The sender IP in both the ARP request
and response and target IP in the ARP response are validated. Packets destined
for the IP addresses 0.0.0.0, 255.255.255.255, and all IP multicast addresses are
dropped. Sender IP addresses are checked in all ARP requests and responses,
and target IP addresses are checked only in ARP responses.
Description
Enter the ARP access list name used here. This name can be up to 32 characters
long.
Enter the VLAN ID list used here.
Select whether to use a static ACL or not here by either selecting Yes or No.
325