D-Link DXS-3400 SERIES Web Ui Reference Manual page 336

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
ARP Inspection Port Settings
This window is used to display and configure the ARP inspection port settings.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP Inspection Port
Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port ~ To Port
Rate Limit
Burst Interval
Trust State
Click the Apply button to accept the changes made.
Click the Set to Default button to change the information to the default values.
ARP Inspection VLAN
This window is used to display and configure the ARP inspection VLAN settings.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP Inspection VLAN,
as shown below:
The fields that can be configured are described below:
Figure 9-47 ARP Inspection Port Settings Window
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Enter the rate limit value here. This value must be between 1 and 150 packets per
seconds.
Enter the burst interval value here. This value must be between 1 and 15. Tick the
None option to disable the option.
Select to enable or disable the trust state here.
Figure 9-48 ARP Inspection VLAN Window
326