D-Link DXS-3400 SERIES Web Ui Reference Manual page 294

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Sequence No.
Action
Protocol Type
Source
Figure 8-16 Extended Expert ACL (Add Rule) Window
Description
Enter the sequence number of this ACL rule here. The range is from 1 to 65535. If
this value is not specified, the system will automatically generate an ACL rule
number for this entry.
Select the action that this rule will take here. Options to choose from are Permit
and Deny.
Select the protocol type option here. Options to choose from are TCP, UDP,
ICMP, EIGRP (88), ESP (50), GRE (47), IGMP (2), OSPF (89), PIM (103), VRRP
(112), IP-in-IP (94), PCP (108), Protocol ID, and None.
• Value - The protocol ID can also manually be entered here. The range is
from 0 to 255.
• Mask - After selecting the Protocol ID option, manually enter the protocol
mask value here. The range is from 0x0 to 0xFF.
• Fragments - Select this option to include packet fragment filtering.
Select and enter the source IP information here. Options to choose from are Any,
Host, and IP.
• When the Any option is selected, any source traffic will be evaluated
according to the conditions of this rule.
• When the Host option is selected, enter the source host's IP address here.
• When the IP option is selected, the Wildcard option will also be available.
Enter the group of source IP addresses by using a wildcard bitmap. The bit
284