D-Link DXS-3400 SERIES Web Ui Reference Manual page 78

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Interface VLAN
Destination IPv6 Address
Output Interface VLAN
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
DHCPv6 Local Relay VLAN
This window is used to display and configure the DHCPv6 local relay VLAN settings. This window is used to enable
DHCPv6 local relay on a VLAN or a group of VLANs.
To view the following window, click Management > DHCP > DHCPv6 Relay > DHCPv6 Local Relay VLAN, as
shown below:
The fields that can be configured are described below:
Parameter
DHCPv6 Local Relay VID
List
State
Figure 4-56 DHCPv6 Relay Interface Settings Window
Description
Enter the interface's VLAN ID used in the DHCPv6 relay here. The range is from
1 to 4094.
Enter the DHCPv6 relay destination address.
Enter the output interface's VLAN ID for the relay destination here. The range is
from 1 to 4094.
Figure 4-57 DHCPv6 Local Relay VLAN Window
Description
Enter the DHCPv6 local relay VLAN ID(s) here. A series of VLAN IDs can be
entered, separated by commas, or a range of VLAN IDs can be entered,
separated by a hyphen. Select the All VLANs option to use all the configured
VLANs.
Select to enable or disable the DHCPv6 local relay feature on the specified
VLAN(s). When DHCPv6 local relay is enabled, the Switch will add Option 37 and
68