Initial Setting - Mitsubishi Electric MELSEC iQ-F FX5 User Manual

Initial setting

Set the procedure for the initial settings when registering the initial settings of a remote device station using an engineering
tool. The initial settings are reflected to the remote device station by turning on 'Remote device station initialization procedure
registration instruction' (SB000D)
Setting method
The procedure for the initial settings is shown below.
1.
Set "Target Station No." in the "Remote Devlce Station Initial Setting Target Station No. Setting" window.
2.
Double-click the number of registered procedures displayed on the right side of the set target station number, and set
each item in the "Remote Device Station Initial Setting Procedure Registration" window.
3.
Click the [OK] button to finish the remote device station initial setting.
4.
When the initial settings are completed, write the settings to the CPU module using the engineering tool.
5.
Start the initial settings by turning on 'Remote device station initialization procedure registration instruction' (SB000D).
While the initial settings are being executed, 'Execution status of remote device station initialization procedure' (SB005E) is
on.
Also, the execution procedure number and the target station number for the procedure registration are stored in 'Remote
device station initialization procedure registration execution individual information' (buffer memory address: Un\G23680 to
Un\G23703).
6.
When the initial settings are completed for all the set stations, 'Completion status of remote device station initialization
procedure' (SB005F) is turned on.
The stations where the initial settings are completed can be checked with 'Remote device station initialization procedure
registration completion status' (SW0164, SW0165). (Page 148 List of link special register (SW) areas)
Also, the execution results are stored in 'Remote device station initialization procedure registration instruction result'
(SW005F). The data stored in 'Remote device station initialization procedure registration execution individual information'
(buffer memory address: Un\G23680 to Un\G23703) become FFH. ( indicates the target station number for the initial
settings.)
7 PARAMETER SETTINGS
7.3 Basic Settings
7
67